Plumbing services and what they cost
Family-run plumbing in Plano — upfront prices, same-day service. Below is every job we take, written out plainly, with the price range you can expect before anyone picks up a wrench. If your problem is not on this list, call and ask. We will tell you straight if it is not our work.
Call (972) 555-0184 Request an estimate
- Diagnostic fee
- $59
- After-hours call-out
- $129
- Licence
- TX M-41887
- Years in Plano
- 17
Emergency leak and burst-pipe repair
If water is moving and you cannot stop it, shut the main off at the street and call. The main shutoff is usually in a concrete box near the kerb, under a lid marked WATER. If you cannot find it, call anyway and we will talk you through it while the van is rolling.
We handle split copper, failed PEX crimps, slab leaks, hose bibb blowouts, pinhole leaks behind drywall, and the supply line under the sink that let go while you were at work. Most repairs are done the same visit. If a wall has to come open, we cut the smallest patch that lets the work happen and we tell you before we cut.
After-hours response
Marcus answers the phone himself from 6am to 10pm, seven days. After 10pm the line goes to his mobile for active flooding only — no voicemail maze. Typical arrival inside Plano is 40 to 70 minutes. Frisco, Allen, Richardson and Murphy usually run 60 to 90.
-
Visible pipe repair
Accessible copper or PEX repair in a cabinet, garage or attic. $185 to $420 including the fitting and the pressure test afterwards.
-
Slab leak location
Acoustic and pressure testing to pinpoint a leak under the foundation. $325 flat, credited against the repair if you go ahead with us.
-
Slab leak repair
Reroute overhead through the attic in most Plano homes — cheaper and less destructive than breaking concrete. $1,400 to $3,200 depending on run length.
-
Whole-house repipe
When a house has had three pinholes in a year, patching stops making sense. PEX repipe on a typical 2,200 sq ft single-storey: $6,500 to $11,000.
Water heaters: repair, replacement and tankless
A tank heater in North Texas lasts about ten to thirteen years. Our water is hard, and the sediment that settles in the bottom of the tank is what finally kills it. If yours is older than twelve and the hot water has gone lukewarm or rusty, we will say so rather than sell you a $300 repair on a tank with a year left.
Plenty of problems are worth fixing, though. A failed thermocouple, a burnt-out element, a bad thermostat or a tripped T&P valve are all cheap and quick. We check those first.
What we charge
-
Repair
Element, thermostat, thermocouple, gas valve or T&P replacement: $140 to $390 fitted.
-
Tank replacement
40 or 50 gallon gas or electric, swapped same day, old unit hauled away: $1,250 to $2,100 all in.
-
Tankless conversion
Gas line sizing, venting, mounting and a condensate route. $3,400 to $5,600 depending on how much gas line has to change.
-
Annual flush
Drains sediment and checks the anode rod. $95 on its own, free if we installed the heater.
Honest note on tankless: it is a good fit if you run out of hot water with a family of four or more, or you want the garage floor space back. It is not cheaper to run in a two-person house. We will tell you which one you are.
Drain cleaning, camera inspection and root intrusion
Slow drains get blamed on hair. In Plano, half the time it is roots. Houses built before the mid-eighties around Douglass and Haggard often still have clay sewer lines, and the live oaks find every joint.
We start with a cable machine. If the line clears and stays clear, that is the end of it. If it backs up again within a few weeks, we put a camera down and show you the screen — you see what we see, and you get a recording of it by email.
-
Sink, tub or shower
Cabled and tested, including pulling the P-trap if needed. $145.
-
Main line clearing
Through an existing cleanout. $225. If there is no cleanout and we have to pull a toilet, add $85.
-
Camera inspection
$195, with video sent to you. Free when it follows a main line clearing we did.
-
Hydro jetting
Cuts roots and scours grease off the pipe wall. $450 to $700 depending on line length and access.
If the camera shows a collapsed or offset clay line, jetting is a stopgap, not a fix. We will quote a spot repair or a pipe burst and we will show you the footage that justifies it.
Bathroom remodels and fixture replacement
We do the plumbing side of a remodel properly and we coordinate the rest. Marcus handles the rough-in, the valve work and the final set. For tile, glass and electrical we bring in the same two crews we have used for a decade, and you get one schedule and one point of contact.
A straight swap — same layout, new fixtures — is two to four days. Moving a toilet or converting a tub to a curbless shower means opening the floor, and that is one to three weeks depending on tile.
Typical ranges
-
Toilet replacement
New wax ring, new supply line, old unit removed. $280 to $450 plus the fixture.
-
Faucet or vanity set
Faucet swap $165. Vanity and top set with new angle stops $420 to $750.
-
Tub to shower conversion
Plumbing, pan, valve and tile. $6,800 to $13,500 depending on tile and glass choices.
-
Full bathroom remodel
Hall bath, same footprint, mid-range finishes: $14,000 to $26,000. Primary baths run higher.
Remodel quotes are fixed in writing before demolition, with an allowance line for fixtures so you can choose them without the number moving underneath you.
Upfront pricing
Here is the whole system. You pay $59 for the diagnostic visit. Marcus looks at the problem, tells you what it is, and hands you a written price for the fix. If you say yes, the $59 comes off the bill. If you say no, you have paid $59 for a straight answer and you owe nothing else.
Every number above is a range because houses differ. The number you are given at your kitchen table is not a range — it is the price. It does not change once work starts unless we find something we could not see, and if that happens we stop and show you before we go further.
Never charged extra
-
Travel inside our area
Plano, Allen, Frisco, Richardson, Murphy, Wylie and Parker. No mileage, no fuel surcharge, no trip fee on top of the diagnostic.
-
Parts runs
If we have to drive to the supply house mid-job, you are not billed for that hour. That is our planning problem, not yours.
-
Cleanup and haul-away
Old heaters, old toilets, offcuts and packaging go in the van. Floors get a drop cloth and a mop on the way out.
-
Weekend rate on bookings
A scheduled Saturday appointment costs the same as a Tuesday. The $129 after-hours fee applies only to genuine out-of-hours emergencies.
He quoted $1,480 for the slab reroute, found a second bad joint, fixed it, and still charged $1,480. I have never had that happen with a contractor before.
Dana R., Plano — Russell Creek
Warranty, licence and insurance
Paperwork matters when water is involved. Ours is current and we will show it to you at the door without being asked.
- Master plumber licence
- TX M-41887
- Responsible party
- Marcus Oyelaran
- General liability
- $2,000,000
- Workers' comp
- Carried on all crew
What the warranty covers
-
Labour: 2 years
If a joint we soldered or a fitting we crimped fails within two years, we come back and redo it at no charge, including the call-out.
-
Parts: manufacturer term
Usually 6 to 12 years on a tank heater, up to 15 on tankless. We register the warranty in your name and email you the certificate.
-
Drain clearing: 90 days
If the same line blocks again inside 90 days we clear it free and run the camera free. That is how we find the real cause.
-
Remodels: 2 years
Covers all plumbing work and the valve sets. Tile and glass carry the installing trade's own warranty, named on your invoice.
Permits are pulled through the City of Plano where the code requires one — water heater replacements, repipes, and any remodel that moves a drain. The permit cost is listed as its own line on your quote, at cost, with no markup.
Ask for a price
Tell us what is happening and we will reply with a range and the next available slot, usually within a couple of hours during the day. If water is actively running, skip the form and call (972) 555-0184.
Still not sure it is our kind of job?
Call and describe it. If it is gas-appliance work, well pumps or anything we are not the right person for, we will say so and tell you who is. No charge for that conversation.